Category Archives: Surface Acoustic Wave Devices

Here is my first semester graduate project in embedded design using assembly and ANSI-C. The details are available below: Design of a low frequency signal generator and analysis

Here is my suggested method for improving misalignment among carbon nanotubes required for fabrication of CNFET. This work presented here is my mid-term project at University of Texas at Arlington. All rights reserved. Challenges and Strategies for improvement of Carbon-Nanotube FET technology

Hi, Earlier works of mine included SAW modeling on VHDL-AMS. However, AMS does not support frequency domain modeling because DAE’s used by AMS are not sufficient to  describe such models. So, in my equivalent network for SAW, I have replaced the characteristic … Continue reading →

Hi everyone, I am a final year student from Electronics Department at JIIT, Noida, India. This blog is an effort to present my views on MEMS to newbies and experts. I am working hard on exploring the aspects of MEMS and … Continue reading →